Primer paints may be oil- or water-based and are used to seal unpainted surfaces to prevent covering coats of paint soaking in. The appropriate type of primer should be used for the surface being painted - wood, metal, plaster or tiles. There are some 'all purpose primers' available which are designed for two or more of these surfaces. A miniature painting, as the name signifies, is an intricate, colorful illuminations or painting, small in size, executed meticulously with delicate brushwork. The colors used in miniatures are generally derived from natural sources and materials. Some of the paintings use pure gold and other precious gems and stones to extract the colors for beautifying these miniature paintings. India has a long and varied tradition of miniature paintings. Jodhpur School: The centre of this hand made paintings are love scenes then the other art figures. The Jodhpur School of Miniature paintings depict love scenes of lovers Dhola and Maru on camel back. There are hunting scenes with elephants and horses. The major colors used in this style of painting are gold and stone color.
WALL PAINTING TIPS. · Paint around the trim first, including edging around the ceiling. · When painting with a gloss finish, make the final brush strokes away from the light source of the room. The tiny ridges that a brush leaves won't be as pronounced. Use the same "wet to dry" method of painting. You'll need a large compressor, not just the typical 20 gallon variety most of us have. This is a 60 gallon, vertical compressor with typically a 5+ hp motor. Then you'll need a decent paint gun (possibly 2; one for primer and one for color) which again is an expense. Then there's the question of where you'll paint the car. Renting a paint booth is best, but can be expensive and hard to find. You can always seal up your garage or shoot out in the wetted down driveway, but you'll inevitably get dirt and moisture into the paint. Intensity refers to a colors brightness or saturation. Intensity refers to how pure a color is. For instance, if you were to use cadmium red straight from the tube, it would have a high intensity. If you were to mix it with another color however, its intensity would be diminished. Once you figure out which position is prime and which position is spray, place the valve in the prime position and grab the primer hose. Point the primer hose in the empty bucket near the top and at an aproxx.45 degree angle from the side (the reason for this is that there is likely to be pressure still built up in the airless and when you first switch on the airless to prime it, paint will likely burst out of the primer hose and you don't want to have it go everywhere). Now turn the airless paint sprayer on and you will see that the airless is sucking up the new paint and pumping out the primer hose. At first you will typically see a cleaning solution come out followed by your paint. When you see your paint coming out switch over the primer valve to the other position and you will see the airless pumping paint into the main hose.