Tropical flower coloring pages for kids

Published at Wednesday, 25 March 2020.

WALL PAINTING TIPS. · Paint around the trim first, including edging around the ceiling. · When painting with a gloss finish, make the final brush strokes away from the light source of the room. The tiny ridges that a brush leaves won't be as pronounced. Use the same "wet to dry" method of painting. Preparation, the key to a successful paint job is to take the correct steps when preparing the job. Preparation for this article, has two parts, the first part is wall prep. The walls you are going to paint may have nail holes or imperfections that need to be filled before you paint. The proper way to fill them, if they are smaller is with water putty, by simply forcing a little bit of the putty in the hole and breaking it off flush with the surface. For larger depressions, use a drywall compound or spackle, which may require a second application to fully fill the indentation and make the repair/"patch" flush with the wall. The lite version of Galkyd is simply thinner. I use it more than the other. I love it. Paintings I did 16 years ago using Galkyds look as pristine as the day I painted them. You'll also need a canvas and some paint. I buy a tube of red, green, blue, purple, yellow, brown, white and black. I prefer what's called Ivory Black and a soft mixing white as you'll add white to a lot of different colors to make lighter versions. From these basic colors you can make any exotic color by mixing them in combination's. Be creative and experiment. And don't be afraid of color, because color is the most popular in museums! The bright paintings are historically the crowd favorites. As for color variety from these basic colors, mix red and white to make pink, mix yellow with green to make lime green, white with blue to make light blue, white with black to make gray, etc. Use your common sense and play with it! You'll also need pencils, an eraser and some Turpentine or Turpentine substitute. Keep your brushes soaking in it in a plastic cup to keep them clean and ready for your next color choice.... and to keep them from drying out.

Definitely good inside the house is a new vinyl primer-sealer to be used as a base coat under any paint. It dries in as little as 30 minutes. The second part of preparation is surface prep, it addresses covering the surfaces you do not want to get any paint on. A little plastic sheeting will go along way to keeping paint off of floors, window coverings, handrails, cabinets, counter tops, etc... And, if you are not confident with your ability to paint a straight line next to door casing, baseboards, cabinets or hardware protect these surfaces using masking tape. There are two basic types of masking tape white/yellow and blue. The white tape sticks to surfaces better but, can pull off finishes on cabinets or stained woodwork. Blue tape usually will not pull off finishes but, does not stick as well, this will probably be the tape to use for most applications. Always wipe down or dust the surface you will be masking to assure the best tape adhesion possible. If you use blue tape you may need to re-rub down the tape before painting next to it, only mask off areas with blue tape that you will be painting for a given day. With either tapes, do not assume the are a force field that paint will not penetrate, use them as a reference and dry brush the paint next to the edge of the tape and avoid soaking the edge of the tape with a lot of paint, this will cause the paint to "bleed" through giving you an undesired look. If you will need to apply multiple coats of paint, on the first coat, paint as close to the tape as you can, not really getting paint on the tape. With the second coat or a one coat application, you can use the tape more of like a paint barrier and get a little more paint on the tape if you immediately remove each section of tape after painting the section, this will keep the paint from sitting on the tape and "bleeding" behind it. Also, if you get a lot of paint on the tape it is not good to let the paint dry on the tape because some paints (especially the glossier paints) will peel if allowed to dried, with the tape when it is pulled off. White tape should not be left on for longer than a couple of days and I suggest not leaving it on more than a day in areas that receive long periods of direct sunlight. Blue tape can be left on for days, if it will stay on, there again it does not stick as well and may need rubbed down again immediately before painting up next to it. Once the drywall compound/spackle has had sufficient time to dry, you will need to lightly sand the surface of the repair to smooth out any ridges that may have been caused while "coating" the patch. Once you have the surface sanded smooth, take a wet sponge or cloth and, by lightly washing/rubbing, blend the outside edge of the drywall compound/spackle back into the wall. For a smaller repair, you can wash away the excess drywall compound, leaving only the compound/spackle only in the area where the indent was filled. For a larger hole, after filling, sanding and using a wet sponge to blend the outside edge of the compound back into the wall, it may be necessary to texture the area in order to give the smooth patch the appearance of the existing wall. We are living in a highly pressurised and competitive world. There are more people chasing fewer jobs and in order to compete and survive in this world our children need to be as highly educated as possible. This has led parents to pressurise play-schools and nursery schools to begin teaching children reading, writing and arithmetic in the hope that they will be better prepared for formal schooling when they enter grade 1.