WALL PAINTING TIPS. · Paint around the trim first, including edging around the ceiling. · When painting with a gloss finish, make the final brush strokes away from the light source of the room. The tiny ridges that a brush leaves won't be as pronounced. Use the same "wet to dry" method of painting.
Now here comes the fun part doors and wood work. This is where most people opt to use latex which is a huge mistake. Your home is your biggest investment don't cut corners on it's aesthetics. You want the finish on your woodwork to stand out from the walls especially if you have crown moulding or waynes coating. Don't be fooled by water based products that claim to give the look and finish of oil. It's just good marketing preying on people's fears of painting with oil. Don't believe the hype as those samples they show you have 3 or 4 coats that have been professionally sprayed in a dust free environment. You will not get the same results I can promise you that. You have a choice of semi-gloss or gloss finish. I prefer gloss because to me it gives you a bit more durability and shine. Either one will be fine for your project. Now let's get started.
Semi-gloss paints are very similar to gloss plaints except it has lesser sheen. Semi-gloss is also suitable for rooms with high humidity (best used for children's room) and can be used for trim works and casings. These paints ensure maximum durability.
Even if you don't need to apply a coat of primer before your new coats of paint, doing so will always save you money. Whether you use white or tinted primer, a coat of primer is always more cost effective for one simple reason: It is cheaper! In fact, primer may cost as little as half as much as standard paint. If you get it tinted the same as your paint, then it is cheaper by the coat. If you use white, as in the first scenario above, it will also minimize the number of coats of paint you have to apply. Either way it reduces how much paint you have to buy. Do you want to learn more about maximizing your paint color coverage, minimizing your paint usage, optimizing coats, and perfecting your primer?
Concrete Floors. Two general types of paints for concrete floors are varnish and rubber-base paint. Each has its limitations and the finish cannot be patched without the patched area showing through. Floor and deck enamel of the varnish type gives good service on concrete floors above grade where there is no moisture present.
Use Tinted Primer for Dark Paint Colors.In our second case, suppose you want to apply a deep, dark blue to a beige wall. The good news is that it will be easier to darken a light color than it was to lighten a dark color. In fact, it may only take 2 - 4 coats to get total color coverage in this scenario. The bad news is that if you start out with a white primer you are already moving in the wrong direction. Doing so could increase the number of paint coats you need to 3 - 6... plus the coat of primer! That's a lot of painting!
The stencil must be held very firmly against the surface with one hand, and the stencil brush worked over it quickly with the other hand. Or, if you have an assistant, it is best for one person to keep the stencil steady, while the other does the painting. In removing the stencil, make sure you pick it up without smudging.