Blue is the color of calmness and peace. It draws in and intoxicates. The strength of this color is as a rule underestimated. It creates precondition for deep reflection about life, calls to find the meaning and truth, it calls for not sensual but rather spiritual impressions.
You scuff up existing paint for two reasons. First, you want to get rid of any oil, grease or dirt trapped in the top layer of paint. This is the stuff that cleaners and degreasers can't get off. The second reason to scuff is to set up a physical bond for the new primer and paint to adhere to. You want to give the old paint some tooth so the new sticks better.
WALL PAINTING TIPS. · Paint around the trim first, including edging around the ceiling. · When painting with a gloss finish, make the final brush strokes away from the light source of the room. The tiny ridges that a brush leaves won't be as pronounced. Use the same "wet to dry" method of painting.
Hope this helps you in deciding complete exterior paint job, or partial trim only exterior paint job, saving painting costs when you can, from your local area painting contractor.
Solvent or oil-based paints are used where a tough, durable finish is required for interior and exterior timber, masonry and furniture - although, as mentioned above, the new generation of acrylics and multi-surface paints offers viable alternatives. In general, brushes need to be cleaned with turpentine or white spirit.
Red color belongs to the three main colors (together with blue and yellow). This color has a lot of shades from light pink to reddish brown. Red is an ideal irritant, there is a reason it is used in corrida to irritate the fighting bulls.
Always use a sanding block for flat surfaces. Just your hand behind a thin piece of sand paper can leave grooves and low spots. It's also easier on your hands. For inside curves try wrapping the sand paper around a short section of garden or heater hose. This will help approximate the concave curve and help stay away from sanding through hard edges. On hard edges, like the top ridge of a fender or leading edge of a hood, you need to do this by hand. A sanding block will quickly dig right through the paint on a hard edge and take you down to bare metal. This means primer and more sanding.