If rubber-base paint has been used, the caustic soda treatment may not be effective and it may be necessary to use an organic solvent type of paint remover. Caution: - When using caustic soda or lye, avoid splashing eyes, skin, and clothing.
Is it possible to color or highlight overly curly hair? Yes, it is. Coloring services are available for all hair types. Stylists use individual techniques to color each hair type. This is decided by your individual hair stylist.
When you are including the finishing touches on a area with accessories, make sure that you remember this one important thing.. It is important to know which color is dominant. Do you desire for things to stay that way? Now highlight the main color with your accessories. Using accessories like paintings, throw pillows and baskets in bolder colors can help detract attention from other parts of the room.
"Boxing" is a good method of mixing paints. Since paint is a mixture of solids and liquids, it is important that it be mixed thoroughly before using. To do this, the greater portion of the liquid contents of the can should be poured in a clean bucket somewhat larger than the paint can. Then, with a stiff paddle, the settled pigment in the original container should be loosened and any lumps broken up. After this, mix the material in the container thoroughly, using a figure 8 motion, and follow with a lifting and beating motion. Continue stirring the mixture vigorously while slowly adding the liquid that was previously poured off the top. Complete the mixing by pouring the paint back and forth from one container to the other several times until the entire amount is of uniform consistency.
Are the contours rough or concealed?
Always use a sanding block for flat surfaces. Just your hand behind a thin piece of sand paper can leave grooves and low spots. It's also easier on your hands. For inside curves try wrapping the sand paper around a short section of garden or heater hose. This will help approximate the concave curve and help stay away from sanding through hard edges. On hard edges, like the top ridge of a fender or leading edge of a hood, you need to do this by hand. A sanding block will quickly dig right through the paint on a hard edge and take you down to bare metal. This means primer and more sanding.
Satin or silk - Water-based vinyl or acrylic paint for walls in high-wear areas, such as hallways and kitchens. A satin finish will be slightly shinier than silk.