If white color can be presented as a sum of all colors, then black is kind of like a lack of color. However, this color is not very important in the interior. Every evening we go back to night with pleasure to rejuvenate our strength. It is this color that gives the beginning to everything new. Black color is indispensable for contrast accentuation and separation of other colors, giving them brightness and expressiveness. It makes the interior graphic and clear as well as very stylish. Paint & Paper Library arranges its colours in five shades from light to dark to help select coordinating colours for ceilings, cornices, walls, doors and woodwork. If you are decorating around bold furnishings, such as a sofa or curtains, look at paint colours from the same fabric house as they are most likely to be sympathetic. The second part of preparation is surface prep, it addresses covering the surfaces you do not want to get any paint on. A little plastic sheeting will go along way to keeping paint off of floors, window coverings, handrails, cabinets, counter tops, etc... And, if you are not confident with your ability to paint a straight line next to door casing, baseboards, cabinets or hardware protect these surfaces using masking tape. There are two basic types of masking tape white/yellow and blue. The white tape sticks to surfaces better but, can pull off finishes on cabinets or stained woodwork. Blue tape usually will not pull off finishes but, does not stick as well, this will probably be the tape to use for most applications. Always wipe down or dust the surface you will be masking to assure the best tape adhesion possible. If you use blue tape you may need to re-rub down the tape before painting next to it, only mask off areas with blue tape that you will be painting for a given day. With either tapes, do not assume the are a force field that paint will not penetrate, use them as a reference and dry brush the paint next to the edge of the tape and avoid soaking the edge of the tape with a lot of paint, this will cause the paint to "bleed" through giving you an undesired look. If you will need to apply multiple coats of paint, on the first coat, paint as close to the tape as you can, not really getting paint on the tape. With the second coat or a one coat application, you can use the tape more of like a paint barrier and get a little more paint on the tape if you immediately remove each section of tape after painting the section, this will keep the paint from sitting on the tape and "bleeding" behind it. Also, if you get a lot of paint on the tape it is not good to let the paint dry on the tape because some paints (especially the glossier paints) will peel if allowed to dried, with the tape when it is pulled off. White tape should not be left on for longer than a couple of days and I suggest not leaving it on more than a day in areas that receive long periods of direct sunlight. Blue tape can be left on for days, if it will stay on, there again it does not stick as well and may need rubbed down again immediately before painting up next to it.
Once the drywall compound/spackle has had sufficient time to dry, you will need to lightly sand the surface of the repair to smooth out any ridges that may have been caused while "coating" the patch. Once you have the surface sanded smooth, take a wet sponge or cloth and, by lightly washing/rubbing, blend the outside edge of the drywall compound/spackle back into the wall. For a smaller repair, you can wash away the excess drywall compound, leaving only the compound/spackle only in the area where the indent was filled. For a larger hole, after filling, sanding and using a wet sponge to blend the outside edge of the compound back into the wall, it may be necessary to texture the area in order to give the smooth patch the appearance of the existing wall. Better still, you don't have to spend hours getting ready and hours cleaning up afterward. Premixed paints, electric-drill attachments and self-dispensing calking guns make short work of preparation. Cleaning up is a soap-and-water job for the rubber paints, or a quick dip in special cleaners for the oils. Disposable dropcloths and paper paint pails are used once and thrown away. On the other hand, a color chosen one or more shades lighter than your existing color will be more damaging because of the use of a lifting agent involved. You see, when going lighter with your hair color, there is always a lifting process used to make your natural color many shades lighter. Such as your hair stylist determines, to have the proper out come of the final hair color. The color desired is actually being deposited in the last fifteen to thirty five minutes of the process, depending on the color line being used. Thus, the hair can become a bit dryer from the lighter hair coloring process. We have color care shampoos and conditioners to solve the drying affect of the hair color. The result, beautiful hair. Satin or silk - Water-based vinyl or acrylic paint for walls in high-wear areas, such as hallways and kitchens. A satin finish will be slightly shinier than silk.