Most of us look to save where we can, especially in this day and economic conditions. House painting is no different, when it comes to saving money. A home exterior weathers from harsh elements of heat, cold, sun, and snow, and exterior paint ages over time needing repainting. Exterior trim, being that of solid wood is normally the first to show signs of painting maintenance. Many times a homeowner happens to call, asking for only painting the trim. Trim paint jobs sound good at first, but have some underlying thoughts may have not been considered. Below are things to consider when considering painting trim only.
Water-thinned interior paints are calcimine, casein, resin-emulsion, and gloss water paints. Calcimine consists of powdered whiting and clay mixed with an animal-glue binder and a preservative. It cannot be recoated, but can be easily washed off before redecorating.
Limewash - Made from slaked lime and water, this paint is good for porous surfaces such as brickwork, render and plaster and gives a chalky finish. It is available from specialist companies.
A Gloss paint is easy to clean and resists scuffs better. This is ideal for rooms that are constantly used. Most gloss paints are best recommended to use on woodworks, baseboards, kitchen and bathroom walls, doorjambs, and window casings. The downside of using gloss paints, however, is the noticeable imperfections in the wall surface.
First consider the size of the painting. The more impressive the subject, the higher the emotions it appeals to, the bigger it is. Religious, mythological paintings are often huge - their massive energy makes you shiver. It is pretty understandable with figurative paintings like Rafael's "The Sistine Madonna", and more subtle with color field paintings of Mark Rothko. People are often overwhelmed with religious tremor in the presence of his artwork, and the size factors in. Also, the subject often calls for larger canvases - battle scenes need space and cannot be fitted into a smaller painting, while some subjects will get lost unless depicted in a smaller size.
Proper brush technique: When "cutting in" with a paint brush you should dip the brush in paint and tap the sides of the bucket on each side of the brush, leaving a good amount on the brush so you are able to minimize the times you will need to dip/load the brush. Next, take the brush and make a one foot to two foot line down the wall about an inch or two away from the trim or surface you are going to paint up next to, this is much like taking a knife full of butter and spreading it across an entire slice of bread. After, spreading the paint over the section, go back and even the paint out evenly across the section and cut up next to the trim with the brush. You want to paint up next to the trim or surfaced to be cut-in with the paint brush after you have released most of the paint on the wall, it is easier to cut in with the tips of the brush exposed and not loaded with a lot of paint.
Always use a sanding block for flat surfaces. Just your hand behind a thin piece of sand paper can leave grooves and low spots. It's also easier on your hands. For inside curves try wrapping the sand paper around a short section of garden or heater hose. This will help approximate the concave curve and help stay away from sanding through hard edges. On hard edges, like the top ridge of a fender or leading edge of a hood, you need to do this by hand. A sanding block will quickly dig right through the paint on a hard edge and take you down to bare metal. This means primer and more sanding.