Monsters, Inc. is a 2001 American computer-animated comedy film produced by Pixar Animation Studios and distributed by Walt Disney Pictures. Featuring the voices of John Goodman, Billy Crystal, Steve Buscemi, James Coburn, and Jennifer Tilly, the film was directed by Pete Docter in his directorial debut, and executive produced by John Lasseter and Andrew Stanton. The film centers on two monsters – James P. “Sulley” Sullivan and his one-eyed partner and best friend Mike Wazowski – employed at the titular energy-producing factory Monsters, Inc, which generates power by scaring human children. The monster world believes that children are toxic, and when a small child enters the factory, Sulley and Mike must return her home before it is too late.
The term paint is used to include paints, varnishes, enamels, shellacs, lacquers, and stains. • Paints are composed of mineral pigments, organic vehicles, and a variety of thinners all combined. • Varnishes are resins dissolved in organic thinners. • Enamels are pigmented varnishes. • Shellac is lac gum dissolved in alcohol. • Lacquers may be both pigmented or clear - the liquid portion usually is treated nitrocellulose dissolve in thinners. • Stains may be pigmented oil or a penetrating type. Many of these materials, such as paints, varnishes, and lacquers, are formulated for specific purposes: • Outside house paints and exterior varnishes are intended to give good service when exposed to weathering • Interior wall paints are formulated to give excellent coverage and good wash-ability. • Floor enamels are made to withstand abrasion. • Lacquers are formulated for rapid drying. • There are also formulas which provide extra self-cleaning, fume- resisting, waterproofing, hardening, flexibility, mildew-resisting, resistance to fading, and breathing qualities. Special Surfaces. WHITEWASH. Whitewashes and lime paints must be thin when applied. In fact, best results will be obtained if the application is so thin that the surface to which it is applied may easily be seen through the film while it is wet. The coating will dry opaque, but two thin Coats will give better results than one thick coat. The salt and alum should be dis-solved in 4 gallons of hot water, after which the molasses may be added to the mixture. The resulting clear solution is then added to the lime paste, stirred vigorously, and thinned with water to the desired consistency. This whitewash has a yellow tinge when first applied, but the color disappears in a few days leaving a white film.
The second part of preparation is surface prep, it addresses covering the surfaces you do not want to get any paint on. A little plastic sheeting will go along way to keeping paint off of floors, window coverings, handrails, cabinets, counter tops, etc... And, if you are not confident with your ability to paint a straight line next to door casing, baseboards, cabinets or hardware protect these surfaces using masking tape. There are two basic types of masking tape white/yellow and blue. The white tape sticks to surfaces better but, can pull off finishes on cabinets or stained woodwork. Blue tape usually will not pull off finishes but, does not stick as well, this will probably be the tape to use for most applications. Always wipe down or dust the surface you will be masking to assure the best tape adhesion possible. If you use blue tape you may need to re-rub down the tape before painting next to it, only mask off areas with blue tape that you will be painting for a given day. With either tapes, do not assume the are a force field that paint will not penetrate, use them as a reference and dry brush the paint next to the edge of the tape and avoid soaking the edge of the tape with a lot of paint, this will cause the paint to "bleed" through giving you an undesired look. If you will need to apply multiple coats of paint, on the first coat, paint as close to the tape as you can, not really getting paint on the tape. With the second coat or a one coat application, you can use the tape more of like a paint barrier and get a little more paint on the tape if you immediately remove each section of tape after painting the section, this will keep the paint from sitting on the tape and "bleeding" behind it. Also, if you get a lot of paint on the tape it is not good to let the paint dry on the tape because some paints (especially the glossier paints) will peel if allowed to dried, with the tape when it is pulled off. White tape should not be left on for longer than a couple of days and I suggest not leaving it on more than a day in areas that receive long periods of direct sunlight. Blue tape can be left on for days, if it will stay on, there again it does not stick as well and may need rubbed down again immediately before painting up next to it. Again, as with Warm and Cool, hair is the most important characteristic in determining Light or Deep. Women with Light coloring tend to have blond, light brown, or light red hair. Women with Deep coloring tend to have brunette, dark red, or black hair. Green is one of the main colors. It is physiologically optimal since this is the color of the natural environment, under the conditions of which people's color vision was created. Green color corresponds to stability, strength, constancy, perseverance, willpower, and the feeling of self-significance. Green color symbolizes prosperity and new beginnings, it calms you down and counterbalances. This color neutralizes the effects of the main colors and helps disperse negative emotions. It brings tranquility and peace, helps concentrate and increasing your likely hood in making decisions. Have plenty of newspaper around. After you clean your brushes wrap them in a plastic bag.