Masonry Walls and Ceilings. Interior masonry walls and ceilings above grade may, in general, be painted in much the same manner as plaster surfaces. Here again, it is necessary to allow adequate time for the masonry to dry before applying paint and, in addition, attention should be given to the preparation of the surface. When decorating a wall containing Portland cement (concrete, for example), it is essential to take precautions against the attack of alkali. For this purpose, alkali-resistant primers such as rubber-base paints may be used when oil paints are to follow.
The paints may be applied by brush or spray; the small spray attachment for vacuum cleaners is very convenient, especially for painting radiators.
EXTERIOR PAINTING. In buying paints that you are going to use for your exterior house, you have to pick a brand that has essential characteristics: hiding power, color retention, chalk-resistance, and blister resistance.
Hair colors come in categories of : Temporary, demi permanent, semi permanent, permanent. Each color line has recommendations on the categories and of uses of their particular types of hair colors. Each line has color enhancers, color glosses and so on. I recommend you have your stylist or colorist educate you on the types she or he will be using on your hair and why. This will help you when choosing shampoos and conditions that will help maintain your hair color between coloring services.
Proper rolling technique: When rolling paint on the wall, get the roller skin evenly loaded with paint and make a V,N or M pattern on the wall, this is to spread the paint across the entire section you will be rolling, then roll back across the section and even out the paint. To properly "lay off" each section, make a final pass of the section applying light pressure to the roller frame arm end of the roller skin and bringing the nap mark (mark created on the pressure applied side of roller skin) across from the beginning of the section to the end of the section, and just repeat all the way down the wall.The V,N or M pattern, will be determine by how far the paint will spread, a V is for less spreading paint and M is for farther spreading paints. Do not "dry roll", which means trying to roll to much of a section at once with very little paint on the roller. Just as important, do not apply to much, if you find you are applying to much, increase the size of the section you are painting i.e. from a V pattern to an N or a N pattern to a M.
Proper brush technique: When "cutting in" with a paint brush you should dip the brush in paint and tap the sides of the bucket on each side of the brush, leaving a good amount on the brush so you are able to minimize the times you will need to dip/load the brush. Next, take the brush and make a one foot to two foot line down the wall about an inch or two away from the trim or surface you are going to paint up next to, this is much like taking a knife full of butter and spreading it across an entire slice of bread. After, spreading the paint over the section, go back and even the paint out evenly across the section and cut up next to the trim with the brush. You want to paint up next to the trim or surfaced to be cut-in with the paint brush after you have released most of the paint on the wall, it is easier to cut in with the tips of the brush exposed and not loaded with a lot of paint.
There are two bases of paint for your house: solvent-based (oil or alkyd) and water-based (latex). Oil-based paints dry slow - usually taking up to 24 hours. The best clean up for an oil-based paint is turpentine or paint thinner. Latex paints' advantage is that it dries relatively fast, but it is not desirable in hot weather or direct sunshine. The best clean up for latex paints requires just soap and water. So if you are painting the inside of your house, it is recommended to use water-based paints, while solvent-based paints are suggested for painting the exterior of your house.