Now that you have the airless paint sprayer and your extension ladders it's time to paint your home. I would highly recommend painting the siding of your home first before painting the trim. The reason being is so you can just spray the house as fast as you can without worrying about painting a section of trim that you already painted. So paint the siding and soffit first followed by painting the trim. Painting the siding using an airless paint sprayer should go pretty fast.
You'll need a large compressor, not just the typical 20 gallon variety most of us have. This is a 60 gallon, vertical compressor with typically a 5+ hp motor. Then you'll need a decent paint gun (possibly 2; one for primer and one for color) which again is an expense. Then there's the question of where you'll paint the car. Renting a paint booth is best, but can be expensive and hard to find. You can always seal up your garage or shoot out in the wetted down driveway, but you'll inevitably get dirt and moisture into the paint.
Painting trim is normally done by roller and brush, not sprayed, so more manual labor is required painting trim, and most cases costing 60% of the total exterior painting job.
Concrete Floors. Two general types of paints for concrete floors are varnish and rubber-base paint. Each has its limitations and the finish cannot be patched without the patched area showing through. Floor and deck enamel of the varnish type gives good service on concrete floors above grade where there is no moisture present.
In conclusion, this article has really just been a "Painting 101" exercise. I'll be adding more articles on the subject once you get more advanced. It's so rewarding to those who stick with it. My work now sells around the world online. So I'm glad I'm glad I stuck with it. It's been infinitely good to me, I've met the most interesting people....including Madonna! And I am so glad I get to do what I want And ultimately it's so gratifying to leave expressions of myself behind forever. And if the owners then turn around and sell my paintings for a fortune later, then that's the cherry on top for me. I feel lucky to have found my calling. And I hope you find it too. And I hope that every single time you view one of my paintings it brings you a little bit of the amazing joy it brought me when I was creating it.
Mixing. Paste paints, such as aluminum, resin-emulsion, and lead-in-oil, should be stirred with a stiff paddle and reduced to painting consistency with the liquids recommended on the manufacturer's labels.
Satin paints offer a good combination of easy-clean and moderate sheen. These paints go a step above eggshell in scrubbing ability. They perform and look great in just about any room.