Free summer themed coloring pages

Published at Thursday, 20 February 2020.

Wood Walls and Trim. New interior walls and wood trim should be smoothed with sand-paper and dusted before painting or varnishing. To preserve the grain of the wood, the surface may be rubbed with linseed oil, varnished or shellacked, and waxed. If an opaque finish is desired, semi-gloss paint thinned with 1 pint of turpen-tine per gallon of paint or the primer-sealer previously described for walls may be used as a priming coat on wood. One or two coats of semi-gloss paint should then be applied over the thoroughly dry prime coat, or if a full-gloss finish is desired, the last coat should be a high-gloss enamel. Special Surfaces. WHITEWASH. Whitewashes and lime paints must be thin when applied. In fact, best results will be obtained if the application is so thin that the surface to which it is applied may easily be seen through the film while it is wet. The coating will dry opaque, but two thin Coats will give better results than one thick coat. Water-thinned interior paints are calcimine, casein, resin-emulsion, and gloss water paints. Calcimine consists of powdered whiting and clay mixed with an animal-glue binder and a preservative. It cannot be recoated, but can be easily washed off before redecorating.

Take off the chrome molding around both the windshield and rear window. You can pick up a special tool at your local Mustang shop or by mail order that removes these quickly without scratching paint. Of course your paint is probably not in great shape at the moment, so a large flat screw driver will also do the trick. For some classic cars it makes sense to even remove the windshield, but classic Mustangs have chrome molding that will help cover any slight overspray. Following a European directive, the British paint industry has reduced VOCs in two stages, the second of which came into force in January last year. Proper rolling technique: When rolling paint on the wall, get the roller skin evenly loaded with paint and make a V,N or M pattern on the wall, this is to spread the paint across the entire section you will be rolling, then roll back across the section and even out the paint. To properly "lay off" each section, make a final pass of the section applying light pressure to the roller frame arm end of the roller skin and bringing the nap mark (mark created on the pressure applied side of roller skin) across from the beginning of the section to the end of the section, and just repeat all the way down the wall.The V,N or M pattern, will be determine by how far the paint will spread, a V is for less spreading paint and M is for farther spreading paints. Do not "dry roll", which means trying to roll to much of a section at once with very little paint on the roller. Just as important, do not apply to much, if you find you are applying to much, increase the size of the section you are painting i.e. from a V pattern to an N or a N pattern to a M. Is some color dominating?