Plaster. New dry plaster in good condition, which is to be finished with a paint other than water paint, should be given a coat of primer-sealer and allowed to dry thoroughly before being inspected for uniformity of appearance. Variations in gloss and color differences in the case of tinted primers indicate whether or not the whole surface has been completely sealed. If not, a second coat of primer-sealer should be applied. If only a few "suction spots" are apparent, a second coat over these areas may be sufficient. Take off the chrome molding around both the windshield and rear window. You can pick up a special tool at your local Mustang shop or by mail order that removes these quickly without scratching paint. Of course your paint is probably not in great shape at the moment, so a large flat screw driver will also do the trick. For some classic cars it makes sense to even remove the windshield, but classic Mustangs have chrome molding that will help cover any slight overspray. If paints have been allowed to stand and hard lumps or skin have formed, the skin or scum should be removed, after which the paint can be stirred and strained through screen wire or through one or two thicknesses of cheesecloth.
How warm does it have to be in order to paint your home? For most paints it typically has to be 37 degrees or warmer in order to paint the exterior of your house. Now if you are painting two coats of paint on your house and it is 55 degrees or cooler for the day, it is a good idea to paint the first coat one day and apply the second coat the day after. If you live in a really dry climate, like Denver, and your painting in the summer months, you can defiantly apply two coats in one day. However, the more humid climates in the south, it is still recommended to paint only one coat per day. Satinwood or semi-gloss - These paints are commonly used on woodwork, such as skirting boards. This sheen level is between eggshell and gloss. Another idea keeping Paint Brush moist until the next paint coat is applied (but not leaving for extended periods) is leaving Brush in container, wrapping top with plastic, sticking handle out the top, and taping around the can. This resembles the Maxwell House Coffee Container mentioned earlier. If plastic and masking tape is still not available, and time between coats is not very long, take that sopping wet rag, draping over the top of paint bucket with Paint Brush still in it. This technique works best when using Latex waterborne paints. Since the trim is the first to go, the main body of the home will be shortly behind requiring painting. If the trim was recently painted, and a few years later the body is ready for paint, all the trim will need to be covered, commonly referred to as masking off. Masking off expends time, labor and material, which adds to the bottom line cost to the remaining 40%, typically costing an additional 25% for masking trim. Thus costing 25% more after both trim and body portions are painted in separate years.