Stripping all the chrome. One of the single most important steps in saving money on a paint job is to strip your Mustang as much as possible yourself. This means taking off anything and everything that won't be painted. The more you take off the less the painter has to mask around. Masking not only takes their time (which costs you money) but it also results in areas that simply can't get a full coat of paint. If you take everything off, then the painters can simply scuff and spray, which will give you better and more consistent coverage.
Wood Walls and Trim. New interior walls and wood trim should be smoothed with sand-paper and dusted before painting or varnishing. To preserve the grain of the wood, the surface may be rubbed with linseed oil, varnished or shellacked, and waxed. If an opaque finish is desired, semi-gloss paint thinned with 1 pint of turpen-tine per gallon of paint or the primer-sealer previously described for walls may be used as a priming coat on wood. One or two coats of semi-gloss paint should then be applied over the thoroughly dry prime coat, or if a full-gloss finish is desired, the last coat should be a high-gloss enamel.
Paint should not be applied to a concrete basement floor until the concrete has aged for at least a year. The floor should be dry when painted, the best time for application being during the winter or early spring (assuming there is some heating apparatus in the basement), when the humidity in the basement is low. In general, three coats of paint are required on an unpainted floor, and the first coat should be thin to secure good penetration. After the paint is dry, it should be protected with a coat of floor wax.
If you decide to do your own body work discuss it with the paint shop first. They'll probably have recommendations on the type of primer you use. Some brands will be more compatible with their primers or color coats. The rule of thumb is to stay within the same brand of paint, both for prep and color. Even the cheapest paint shops typically use a brand name on their intermediate and higher paint jobs. Find out what it is and use the same brand as your primer coat. This will ensure you don't create adhesion problems for yourself down the road.
To balance color, you must grasp the interconnectedness of color schemes. All color interactions are defined in the color wheel, and it has been used to build color schemes for centuries.
Cheaper then doing it yourself. Some would argue that if you're going to all the trouble to fully prep the car yourself, then why not just shoot the paint as well? Why get a shop involved? The answer is simply that you'll get a better job and for less money. Some would argue with this, but the fact is that if you've never sprayed a car before then your first car will have a steep, and expensive learning curve. Laying down an even, consistent coat of paint takes considerable practice. Also, paint and equipment is not cheap. You'll need to buy primer, color coat, clear coat, reducers & catalysts. None of these are inexpensive and you can easily spend as much in paint materials alone as the cheapest paint job at Maaco or similar shop.
When all of the spraying is complete, its time to remove all masking tape and paper and start touching up your entire home. This step is pretty time consuming because this is the final stage that really makes your home look good. The more time you spend here, the better your home will look.