Masonry Walls and Ceilings. Interior masonry walls and ceilings above grade may, in general, be painted in much the same manner as plaster surfaces. Here again, it is necessary to allow adequate time for the masonry to dry before applying paint and, in addition, attention should be given to the preparation of the surface. When decorating a wall containing Portland cement (concrete, for example), it is essential to take precautions against the attack of alkali. For this purpose, alkali-resistant primers such as rubber-base paints may be used when oil paints are to follow. If you have a vinyl top then remove the molding separating the vinyl and paint. Drip rail chrome really should be removed also, but can be extremely hard to take off undamaged. If you plan on buying all new drip molding then definitely remove the old for painting. But if you want to keep the originals then it might be better to leave them on and let the painter mask around. If you have hub caps it's easy to just take them off. While the paint shop should completely mask all four tires, overspray can still find its way in. It's sometimes better to play it safe and just remove wheel covers. Store your leftover paint in plastic Rubbermaid beverage jugs or other plastic seal-able containers. Paint left in the can always gets funny after time. Either the can isn't properly sealed of it gets exposed to extreme heat or cold. I like to store my paint inside where the temperature is controlled.
There is still no standard labelling scheme for paint. The blue globe label, pioneered by B&Q, led to VOC reduction on the mass market and has been adopted by other brands, while the European Ecolabel, recognised in 15 EU member states, looks like a flower and appears on brands such as Earthborn. Germany also has a Blue Angel label and there is a green Nordic Swan as well. You will find more detailed information on most of the paint company's websites, as well as a wealth of practical and design advice. Once the drywall compound/spackle has had sufficient time to dry, you will need to lightly sand the surface of the repair to smooth out any ridges that may have been caused while "coating" the patch. Once you have the surface sanded smooth, take a wet sponge or cloth and, by lightly washing/rubbing, blend the outside edge of the drywall compound/spackle back into the wall. For a smaller repair, you can wash away the excess drywall compound, leaving only the compound/spackle only in the area where the indent was filled. For a larger hole, after filling, sanding and using a wet sponge to blend the outside edge of the compound back into the wall, it may be necessary to texture the area in order to give the smooth patch the appearance of the existing wall. A Gloss paint is easy to clean and resists scuffs better. This is ideal for rooms that are constantly used. Most gloss paints are best recommended to use on woodworks, baseboards, kitchen and bathroom walls, doorjambs, and window casings. The downside of using gloss paints, however, is the noticeable imperfections in the wall surface. SECONDARY COLORS. When you mix two primary colors together, you get a secondary color. The secondary colors are orange, green and violet. Orange is made by mixing red with yellow. Green is made by mixing blue and yellow. Violet is made my mixing blue with red.