Masonry Walls and Ceilings. Interior masonry walls and ceilings above grade may, in general, be painted in much the same manner as plaster surfaces. Here again, it is necessary to allow adequate time for the masonry to dry before applying paint and, in addition, attention should be given to the preparation of the surface. When decorating a wall containing Portland cement (concrete, for example), it is essential to take precautions against the attack of alkali. For this purpose, alkali-resistant primers such as rubber-base paints may be used when oil paints are to follow.
Water-thinned rubber-latex paint is already an old reliable, though it is only about 10 years old. It accounts for a big percentage of all paint sold and is still the most widely available of the easy-to-use finishes. One new type is a combination vinyl-rubber paint that is said to do a better job on interiors than either vinyl or rubber alone because it dries faster, lasts longer and has less sheen.
When you plan with split complementary colors, you begin with a single reference color. Next, choose a color from either edge of the complementary color and use it. While the complementary color scheme is a little more obvious, this scheme can fail totally if you just use paler versions of your warm colors. By the same token, picking a a warm undertone for the main contrasting color and combining it with two cool tones will showcase the warm tone.
The leading brands now flag up paints with lower VOCs and produce paints that are virtually odour-free - the Breatheasy range by Crown is one example. Most leading brands now produce high-quality water-based acrylic paints which outperform the older technologies of vinyl and oils.
The first step is to cover the surface with a coat of paint, using your regular paint brush, or spray, or roller. Then, while the surface is still wet, take the dry stipple brush and energetically with short strokes drive the ends or the bristles into the wet paint. Be sure not to brush across. The result will be clusters of dots. Every few minutes wipe the brush with a cloth, to keep the bristle ends clean and dry.
There are two bases of paint for your house: solvent-based (oil or alkyd) and water-based (latex). Oil-based paints dry slow - usually taking up to 24 hours. The best clean up for an oil-based paint is turpentine or paint thinner. Latex paints' advantage is that it dries relatively fast, but it is not desirable in hot weather or direct sunshine. The best clean up for latex paints requires just soap and water. So if you are painting the inside of your house, it is recommended to use water-based paints, while solvent-based paints are suggested for painting the exterior of your house.
White - is the concentration of all colors from the physical standpoint, since it is the white light that decomposes into all the colors of the spectrum when refracted in the facets of the glass pyramid. White color goes well with all the other colors, it is universal and brings in the element of elegance.