Stripping all the chrome. One of the single most important steps in saving money on a paint job is to strip your Mustang as much as possible yourself. This means taking off anything and everything that won't be painted. The more you take off the less the painter has to mask around. Masking not only takes their time (which costs you money) but it also results in areas that simply can't get a full coat of paint. If you take everything off, then the painters can simply scuff and spray, which will give you better and more consistent coverage.
Flat or Dead-Flat Oil - Provides a completely flat, oil-based finish. Generally used on walls but not suitable for areas of high wear.
Inside the house is where acrylic shines. It dries faster than other types, and it keeps its color better, without yellowing. One disadvantage: It costs more.
Valspar Paint, for instance, also produces paint branded as Laura Ashley, Eddie Bauer, Waverly, and more. These separate lines, or collections, have their own color wheel displays and are usually available wherever the primary brand, Valspar in this case, are sold. Other examples are Disney Paints, currently produced by Behr, and Ralph Lauren and Martha Stewart, formerly produced by Sherwin Williams.
By far, the most important characteristic in determining whether you are Warm or Cool is your hair color. If you can't determine your exact eye or skin tone, then your hair color will provide the answer. Why? It frames your face!
Proper rolling technique: When rolling paint on the wall, get the roller skin evenly loaded with paint and make a V,N or M pattern on the wall, this is to spread the paint across the entire section you will be rolling, then roll back across the section and even out the paint. To properly "lay off" each section, make a final pass of the section applying light pressure to the roller frame arm end of the roller skin and bringing the nap mark (mark created on the pressure applied side of roller skin) across from the beginning of the section to the end of the section, and just repeat all the way down the wall.The V,N or M pattern, will be determine by how far the paint will spread, a V is for less spreading paint and M is for farther spreading paints. Do not "dry roll", which means trying to roll to much of a section at once with very little paint on the roller. Just as important, do not apply to much, if you find you are applying to much, increase the size of the section you are painting i.e. from a V pattern to an N or a N pattern to a M.
Cement-water paints are best suited for application to basement walls which are damp as a result of leakage or condensation. To apply these paints, the same procedure should be followed as is described here for painting exterior masonry walls.