WALL PAINTING TIPS. · Paint around the trim first, including edging around the ceiling. · When painting with a gloss finish, make the final brush strokes away from the light source of the room. The tiny ridges that a brush leaves won't be as pronounced. Use the same "wet to dry" method of painting.
Plastic sheathing and masking tape was not available at the end of the painting project for whatever reason, I have no idea, but you have a Paint Brush that if not cared for will eventually dry up. Last solution that works well, is to take a sopping wet rag, wrapping the Paint Brush up like that burrito you missed wrapping up earlier. This will buy you some time until either you use the paint brush again, or you can properly clean it.
Now here comes the fun part doors and wood work. This is where most people opt to use latex which is a huge mistake. Your home is your biggest investment don't cut corners on it's aesthetics. You want the finish on your woodwork to stand out from the walls especially if you have crown moulding or waynes coating. Don't be fooled by water based products that claim to give the look and finish of oil. It's just good marketing preying on people's fears of painting with oil. Don't believe the hype as those samples they show you have 3 or 4 coats that have been professionally sprayed in a dust free environment. You will not get the same results I can promise you that. You have a choice of semi-gloss or gloss finish. I prefer gloss because to me it gives you a bit more durability and shine. Either one will be fine for your project. Now let's get started.
Definitely good inside the house is a new vinyl primer-sealer to be used as a base coat under any paint. It dries in as little as 30 minutes.
Airless Tip: If you have somebody who can start masking off the trim, have them start on that while you convert the airless to a new color. When changing colors with an airless paint sprayer it is a good idea to have a second bucket filled half way with clean water. Place the intake hose in the clean water gently without getting the old color everywhere in the water. Take the tip out of the airless and spray all of the old paint out of the hose and back into its original paint bucket. Be careful when doing this that you recognize when the paint starts turning watery. When it does point the gun into the first bucket and spray until it looks pretty clean. It doesn't need to be perfectly clean. When it looks good, clean off the intake line in the clean bucket and get the old color off the intake line. Now place the intake line inside of your new trim paint.
However, for the more discerning, Dulux Kitchen & Bathroom paint can be mixed in any one of its 1,200 colours, and Farrow & Ball is launching Modern Emulsion. Designed to complement its original Estate Emulsion, the paint has a slightly higher sheen, is fully washable and available in the full colour range.
Concrete Floors. Two general types of paints for concrete floors are varnish and rubber-base paint. Each has its limitations and the finish cannot be patched without the patched area showing through. Floor and deck enamel of the varnish type gives good service on concrete floors above grade where there is no moisture present.