What colors are prevailing - tonal or local, warm or cold? Solvent or oil-based paints are used where a tough, durable finish is required for interior and exterior timber, masonry and furniture - although, as mentioned above, the new generation of acrylics and multi-surface paints offers viable alternatives. In general, brushes need to be cleaned with turpentine or white spirit. EXTERIOR PAINTING. In buying paints that you are going to use for your exterior house, you have to pick a brand that has essential characteristics: hiding power, color retention, chalk-resistance, and blister resistance.
The salt and alum should be dis-solved in 4 gallons of hot water, after which the molasses may be added to the mixture. The resulting clear solution is then added to the lime paste, stirred vigorously, and thinned with water to the desired consistency. This whitewash has a yellow tinge when first applied, but the color disappears in a few days leaving a white film. Proper rolling technique: When rolling paint on the wall, get the roller skin evenly loaded with paint and make a V,N or M pattern on the wall, this is to spread the paint across the entire section you will be rolling, then roll back across the section and even out the paint. To properly "lay off" each section, make a final pass of the section applying light pressure to the roller frame arm end of the roller skin and bringing the nap mark (mark created on the pressure applied side of roller skin) across from the beginning of the section to the end of the section, and just repeat all the way down the wall.The V,N or M pattern, will be determine by how far the paint will spread, a V is for less spreading paint and M is for farther spreading paints. Do not "dry roll", which means trying to roll to much of a section at once with very little paint on the roller. Just as important, do not apply to much, if you find you are applying to much, increase the size of the section you are painting i.e. from a V pattern to an N or a N pattern to a M. When you plan with split complementary colors, you begin with a single reference color. Next, choose a color from either edge of the complementary color and use it. While the complementary color scheme is a little more obvious, this scheme can fail totally if you just use paler versions of your warm colors. By the same token, picking a a warm undertone for the main contrasting color and combining it with two cool tones will showcase the warm tone. Practically every manufacturer has a "color system," a fat book of color chips with instructions for duplicating each chip. This is accomplished by intermixing cans of colored paint, by adding a concentrated color to a can of white or colored paint, or by adding concentrated color or colors to a can of neutral "base" paint. And for those who don't want any guesswork there's the Color Carousel that mixes the paints right in the store. Whatever the method, the result is a range of colors such as no amateur painter has seen.