Blue is the color of calmness and peace. It draws in and intoxicates. The strength of this color is as a rule underestimated. It creates precondition for deep reflection about life, calls to find the meaning and truth, it calls for not sensual but rather spiritual impressions. Note: How to use an airless paint sprayer. I'm sure the guy at the rental store showed you how to use the airless (typically with his limited experience of actually painting a house), so hopefully I can offer you a couple new ideas on how to paint your home using an airless paint sprayer. When you first get the airless home, set it in the middle of the area that you would like to start painting. Typically the length of the hose is around 50'. Stretch out the hose prior to painting so that you don't have to worry about unraveling it while you are painting on a ladder. It is a good idea to have a 100' extension cord so that you can bring the airless anywhere you wish to paint without any restrictions. Tip: before you plug in the airless into the extension cord, MAKE SURE THE AIRLESS IS OFF! You don't want the airless to start pumping without paint! Now, when you go to set up the airless, before you turn it on, it's a good rule of thumb to have a second empty bucket next to your bucket of paint. I'll explain why in a second. Place both buckets side by side and place the intake hose (with the wire mesh filter end) into your 5 gallon bucket of paint while the primer hose (usually a lot smaller, about the size of a pencil'ish) is placed in the empty bucket of paint. Before you turn on the machine make sure that the airless is set to prime the machine first. There is a primer valve that you can rotate between prime and paint. A good way to see if the valve is set to prime or paint is to try this little test prior to turning the machine on. While turning the valve clockwise a couple times you will notice that the valve handle will separate from the machine in one position (leaving a slight crack between the valve and machine) while the other position the valve is close to the machine. The position in which the valve is separated from the machine is considered the primer position. Do this multiple times to see what I'm talking about. Don't worry if you keep on spinning the valve, you can spin it a million times in one direction and it won't hurt it. Themes of Miniature Art Paintings. After the Mughal reign, which lasted 200 years, by the second part of the 18th century, the Rajput Maharajahs became independent. They employed these highly skilled artists to replace their own artisans, leading to a sort of painting renaissance in northern India. The whole of Rajasthan divided into numerous princely states, patronized miniature art painting. These states had evolved a characteristic style of their own.The paintings of this era have their own unique style, being influenced by the surroundings- the deserts, lakes, hills and valleys, as the case may.Colorful glimpses of history are provided by these paintings depicting hunting and court scenes, festivals, processions, animal and bird life, and scenes from the Raagmala and Raaslila -- Lord Krishna´s life story. Also, courtly lavishness and prosperity have been displayed.
Cold water paints of the casein type may be applied either directly to a plastered surface, or the surface may be first given a coat of primer-sealer to equalize uneven suction effects. The same is true of resin-emulsion paints, with the recommendations of the manufacturer of the product being given preference in case of doubt. Since resin-emulsion paints usually contain some oil in the binder, they should ordinarily be applied only to plaster which has dried thoroughly. Concrete Floors. Two general types of paints for concrete floors are varnish and rubber-base paint. Each has its limitations and the finish cannot be patched without the patched area showing through. Floor and deck enamel of the varnish type gives good service on concrete floors above grade where there is no moisture present. Now that you have primed the airless, make sure that there isn't a tip in the gun of the airless and bring it over to the empty bucket. Since there is typically cleaning solution in the hose leading to the gun it is a good idea to spray that out until you see thick paint coming out. Once you have thick paint coming out you may put your tip back in. Remember that the tip will have an arrow on one side of the handle that shows which direction it must be in, in order to spray. Can you feel the rhythm in repeating some color or combination?