The paints may be applied by brush or spray; the small spray attachment for vacuum cleaners is very convenient, especially for painting radiators. If paints have been allowed to stand and hard lumps or skin have formed, the skin or scum should be removed, after which the paint can be stirred and strained through screen wire or through one or two thicknesses of cheesecloth. When you are including the finishing touches on a area with accessories, make sure that you remember this one important thing.. It is important to know which color is dominant. Do you desire for things to stay that way? Now highlight the main color with your accessories. Using accessories like paintings, throw pillows and baskets in bolder colors can help detract attention from other parts of the room.
Proper rolling technique: When rolling paint on the wall, get the roller skin evenly loaded with paint and make a V,N or M pattern on the wall, this is to spread the paint across the entire section you will be rolling, then roll back across the section and even out the paint. To properly "lay off" each section, make a final pass of the section applying light pressure to the roller frame arm end of the roller skin and bringing the nap mark (mark created on the pressure applied side of roller skin) across from the beginning of the section to the end of the section, and just repeat all the way down the wall.The V,N or M pattern, will be determine by how far the paint will spread, a V is for less spreading paint and M is for farther spreading paints. Do not "dry roll", which means trying to roll to much of a section at once with very little paint on the roller. Just as important, do not apply to much, if you find you are applying to much, increase the size of the section you are painting i.e. from a V pattern to an N or a N pattern to a M. When all of the spraying is complete, its time to remove all masking tape and paper and start touching up your entire home. This step is pretty time consuming because this is the final stage that really makes your home look good. The more time you spend here, the better your home will look. Proper brush technique: When "cutting in" with a paint brush you should dip the brush in paint and tap the sides of the bucket on each side of the brush, leaving a good amount on the brush so you are able to minimize the times you will need to dip/load the brush. Next, take the brush and make a one foot to two foot line down the wall about an inch or two away from the trim or surface you are going to paint up next to, this is much like taking a knife full of butter and spreading it across an entire slice of bread. After, spreading the paint over the section, go back and even the paint out evenly across the section and cut up next to the trim with the brush. You want to paint up next to the trim or surfaced to be cut-in with the paint brush after you have released most of the paint on the wall, it is easier to cut in with the tips of the brush exposed and not loaded with a lot of paint. After the siding of your home is painted you can now start on painting the trim. There are a couple different ways you can go about painting the trim of your house. The first way is to mask off all of the trim so that you can merely spray the trim color on to your house, and the second way is to roll the trim by hand. If you are the only person painting the house I would recommend rolling the trim by hand. The reason being is because it takes a long time to mask off all of the trim on your home compared to just rolling the face of the trim boards. If you have multiple people, it would be faster to have the helpers mask everything off while you start spraying the trim color.